Red Hat Training

A Red Hat training course is available for Red Hat Enterprise Linux

12.19. Partitionieren des Systems

If you chose one of the three automatic partitioning options and did not select Review, skip ahead to Abschnitt 12.20, »Netzwerkkonfiguration«.
Wenn Sie eine der automatischen Partitionierungsoptionen und Angelegte Partitionen prüfen gewählt haben, können Sie entweder die aktuellen Partitionseinstellungen verwenden (klicken Sie auf Weiter) oder die Einstellung mit Disk Druid, dem manuellen Partitionierungstool, verändern.

Anmerkung

Beachten Sie bitte, dass es in der textbasierten Installation nicht möglich ist, mit LVM (Logischen Datenträgern) zu arbeiten. Lediglich die vorhandene Einstellung ist abrufbar. LVM kann nur mit Hilfe des grafischen Disk Druid Programms während einer grafischen Installation eingerichtet werden.
If you chose to create a custom layout, you must tell the installation program where to install Red Hat Enterprise Linux. This is done by defining mount points for one or more disk partitions in which Red Hat Enterprise Linux is installed.

Anmerkung

If you have not yet planned how to set up your partitions, refer to Kapitel 25, Eine Einführung in Festplattenpartitionen and Abschnitt 12.19.4, »Empfohlenes Partitionsschema«. At a bare minimum, you need an appropriately-sized root (/) partition, a /boot/ partition, PPC PReP boot partition, and a swap partition equal to twice the amount of RAM you have on the system.
Partitionieren mit Disk Druid auf IBM System p und System i Systemen

Abbildung 12.16. Partitionieren mit Disk Druid auf IBM System p und System i Systemen

Disk Druid ist das Partitionierungstool, das vom Installationsprogramm verwendet wird. Die Funktionen von Disk Druid sind für eine reguläre Installation völlig ausreichend - nur ganz außergewöhnliche Konfigurationen können mit diesem Tool nicht gemeistert werden.

12.19.1. Grafische Darstellung der Festplatte(n)

Disk Druid bietet eine grafische Darstellung Ihrer Festplatte(n).
Wenn Sie einmal mit der Maus klicken, heben Sie ein spezielles Feld der grafischen Darstellung hervor. Mit Hilfe von zwei Mausklicks können Sie eine der bereits existierenden Partitionen bearbeiten, oder eine Partition an einer freien Stelle erstellen.
Above the display, you can review the Drive name (such as /dev/hda), the Geom (which shows the hard disk's geometry and consists of three numbers representing the number of cylinders, heads, and sectors as reported by the hard disk), and the Model of the hard drive as detected by the installation program.