How to set up the multipath on the physical RHEL 6.4 systems.

How to set up the multipath on the physical RHEL 6.4 systems. Two HBAs connected to FC-Storage.

Started 2013-07-31T11:07:27+00:00 by

Tom Kimm

Responses

MG Red Hat Guru 2875 points

Milan Gandhi

Hello,

You could use the steps described in following knowledge base articles to setup DM-Multipath on the Physical systems:

"How do I setup multipath on a system that already has LVM configured?"
https://access.redhat.com/site/solutions/47894

"How to configure device mapper multipath"
https://access.redhat.com/site/solutions/66281

Kind regards,

Milan.

rh Red Hat Active Contributor 387 points

rhn-support-mkpai

Hello Tom,

The complete guide to multipath is at

https://access.redhat.com/site/documentation/en-US/Red_Hat_Enterprise_Linux/6/html-single/DM_Multipath/index.html

Regards,

-- Pai

Tom Kimm

appreciate it again and have a wonderful day!

Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.