モード 4 802.3ad (LACP) を使用するとボンディングが機能しない
Issue
- ボンディングモード 4 のリンクアグリゲーション制御プロトコル (lacp,802.ad) に設定した 4 つのネットワークデバイスで、アグリゲーションに多数のポート数を持つ 4 つのアグリゲーション id が 1 になります。また、
Partner Mac Address:値は null 値を登録します。
Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
Bonding Mode:IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2 (0)
MII Status: up
MII Polling Interval (ms):200
Up Delay (ms):0
Down Delay (ms):0
802.3ad info
LACP rate: slow
Aggregator selection policy (ad_select): stable
Active Aggregator Info:
Aggregator ID:2
Number of ports:1
Actor Key:17
Partner Key:1
Partner Mac Address:00:00:00:00:00:00
Slave Interface: eth1
MII Status: up
Speed:1000 Mbps
Duplex: full
Link Failure Count:0
Permanent HW addr:9c:8e:99:0c:9f:7a
Aggregator ID:1
Slave queue ID:0
Slave Interface: eth10
MII Status: up
Speed:1000 Mbps
Duplex: full
Link Failure Count:0
Permanent HW addr:00:26:55:e1:68:23
Aggregator ID:2
Slave queue ID:0
Slave Interface: eth2
MII Status: up
Speed:1000 Mbps
Duplex: full
Link Failure Count:0
Permanent HW addr:9c:8e:99:0c:9f:7c
Aggregator ID:3
Slave queue ID:0
Slave Interface: eth9
MII Status: up
Speed:1000 Mbps
Duplex: full
Link Failure Count:0
Permanent HW addr:00:26:55:e1:68:20
Aggregator ID:4
Slave queue ID:0
Environment
- Red Hat Enterprise Linux (すべてのバージョン)
- lacp をサポートする Cisco Switch
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Close
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.