Red Hat Satellite 6.5 List of Network Ports

Solution Verified - Updated -

Issue

The attached PDF and spreadsheet lists all the required network ports for the Satellite, Capsule, and managed hosts as well as the start and endpoint of each communication path.

This matrix table can be used to determine the required network access for the deployed Satellite, Capsule, and managed host topology. It can be used in conjunction with the topology diagrams in the Capsule Networking section of the Satellite 6.5 Planning for Red Hat Satellite 6 guide.

Remember that a Capsule's base system is a client of the Satellite's integrated Capsule and therefore ports for client communication most be open between a Capsule and a Satellite.

Select the "Follow" button below to receive notification of updates.

See the Ports and Firewalls Requirements section of the Red Hat Satellite 6.5 Installing Satellite Server from a Connected Network guide for more information.

NOTE
ICMP to Port 7 UDP and TCP should not be rejected, but can be dropped. DHCP Capsule sends ECHO REQUEST to Client network to verify that an IP address is free. Any response will prevent IP addresses being allocated.

Known Issues

The list is based on the use of ports in a running Satellite or Capsule as reported by the developers. It does not make it clear you will need port 80 open at the very start of the installation of a Capsule. To install the consumer certificate on the base system of a Capsule requires port 80 to be open in the direction of the Satellite.

Environment

Satellite 6.5

Subscriber exclusive content

A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.

Current Customers and Partners

Log in for full access

Log In