Menu Close
Settings Close

Language and Page Formatting Options

4.7. Configuring Virtual NUMA

In the Administration Portal, you can configure virtual NUMA nodes on a virtual machine and pin them to physical NUMA nodes on one or more hosts. The host’s default policy is to schedule and run virtual machines on any available resources on the host. As a result, the resources backing a large virtual machine that cannot fit within a single host socket could be spread out across multiple NUMA nodes. Over time these resources may be moved around, leading to poor and unpredictable performance. Configure and pin virtual NUMA nodes to avoid this outcome and improve performance.

Configuring virtual NUMA requires a NUMA-enabled host. To confirm whether NUMA is enabled on a host, log in to the host and run numactl --hardware. The output of this command should show at least two NUMA nodes. You can also view the host’s NUMA topology in the Administration Portal by selecting the host from the Hosts tab and clicking NUMA Support. This button is only available when the selected host has at least two NUMA nodes.

Note

If you define NUMA Pinning, the default migration mode is Allow manual migration only by default.

Configuring Virtual NUMA

  1. Click ComputeVirtual Machines and select a virtual machine.
  2. Click Edit.
  3. Click the Host tab.
  4. Select the Specific Host(s) radio button and select the host(s) from the list. The selected host(s) must have at least two NUMA nodes.
  5. Enter a number into the NUMA Node Count field to assign virtual NUMA nodes to the virtual machine.
  6. Select Strict, Preferred, or Interleave from the Tune Mode drop-down list. If the selected mode is Preferred, the NUMA Node Count must be set to 1.
  7. Click NUMA Pinning.
  8. In the NUMA Topology window, click and drag virtual NUMA nodes from the box on the right to host NUMA nodes on the left as required, and click OK.
  9. Click OK.
Note

If you do not pin the virtual NUMA node to a host NUMA node, the system defaults to the NUMA node that contains the host device’s memory-mapped I/O (MMIO), provided that there are one or more host devices and all of those devices are from a single NUMA node.