The IPv4 Settings changed from 'Static' to 'Disabled' and Protocol display none after register rhev-h to RHEV-M

Latest response

 

Hi All,

Description of problem:
The IPv4 Settings changed from 'Static' to 'Disabled' and Protocol display none after register rhev-h to RHEV-M(Seen Network Detail Page.png)

Version-Release number of selected component (if applicable):
rhev-hypervisor6-6.4-20130116.3

How reproducible:
100%

Steps to Reproduce:
1. Install rhev-hypervisor6-6.4-20130116.3
2. Configure the network by Static successfully. At this moment
   Protocol:Static
   IPv4 settings is:
   [ ]Disabled [ ] DHCP [*]Static
3. Register RHEVH to RHEVM
  
Actual results:
After step 3:
Protocol:none
IPv4 Settings
[*]Disabled [ ] DHCP [ ]Static

Expected results:
After step 3:
Protocol:Static
IPv4 Settings
[ ]Disabled [ ] DHCP [*]Static

 

iPlease suggest on this. Urgent.

 

Thanks & Regards,

Somnath

Responses

Does the host successfully register with RHEV-M? You probably already checked this but did you make sure you saved the network settings?

https://access.redhat.com/knowledge/docs/en-US/Red_Hat_Enterprise_Virtualization/3.1/html/Installation_Guide/Configuring_Hypervisor_Network_Interfaces1.html

Hi Anthony,

Thanks for replying.

The host is successfully registered with RHEV-M. Because i was able to find out and add in RHEV manager.

I tried to change the IP address of the Host, that was the time when i noticed this issue.

 

Orelse the hosts are working absolutely fine and there is no performance issue.

 

I read in thie mentioned portal (https://bugzilla.redhat.com/show_bug.cgi?id=901438)

that it might be a BUG(Bug 901438), though i am not sure.

 

Please put some more informations regarding.

 

Thanks & Regards,

Somnath