RHEV-M GUI does not show updated size of Direct LUN after resize

Solution Verified - Updated -

Issue

  • The size of direct LUN assigned to RHEV hypervisors was increased from 500 GB to 800 GB form SAN/Storage side.

    After increasing the LUN size from SAN/Storage side, multipath devices on hypervisors were scanned using steps in Solution 65399 and multipath -ll command on hypervisor was showing mpath device size as 800 GB, but the RHEV-M GUI was still showing the size of LUN as 500 GB only.

  • This direct LUN was attached to couple of RHEL virtual machines and they were able to see the new size (800 GB) without any issue.

  • Is there any bug in RHEV-M GUI due to which the new size of direct LUN was not shown correctly event after successful rescan?

Environment

  • Red Hat Enterprise Virtualization 3.3
  • Direct LUN assigned to RHEV-H

Subscriber exclusive content

A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.

Current Customers and Partners

Log in for full access

Log In
Close

Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.