RHEV-H 6 has no network on Cisco UCS blades (enic module parameter problem)

Solution Unverified - Updated -

Issue

The RHEV hypervisor can not be installed onto Cisco UCS B200M2 blade with enic driver using rhevh-6.2-20120209.0.iso.

The reason is that /etc/modprobe.d/vdsm.conf in the intrd image defines parameters for enic module that the module does not support, resulting in a failure to load the kernel module. It's currently defined as below.

options enic lro_disable=1

Environment

  • Red Hat Enterprise Virtualization (RHEV) 3.0
  • Red Hat Enterprise Virtualization Hypervisor (RHEV-H) 6.2 20120209.0.el6_2

Subscriber exclusive content

A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.

Current Customers and Partners

Log in for full access

Log In

New to Red Hat?

Learn more about Red Hat subscriptions

Close

Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.