Broadcom cards fails to initialize with the error 'ethX: Something bad had happen! Aii'.

Solution Verified - Updated -

Issue

  • Broadcom cards produces error  'ethX Something bad had happen! Aii'. and fails to initialize.

  • dmesg logs the following while initializing:

    bnx2x 0000:21:00.0: eth0: Broadcom NetXtreme II BCM57710 XGb (A1) PCI-E x8 2.5GHz found at mem d7800000, IRQ 225, node addr 00:10:18:30:fd:08
eth0: Something bad had happen! Aii!
eth0: Recovery flow hasn't been properly completed yet. Try again later. If u still see this message after a few retries then power cycle is required.

Environment

  • Issue with 2.6.18-238 and 2.6.18-238.5.1
  • Red Hat Enterprise Linux 5

Subscriber exclusive content

A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.

Current Customers and Partners

Log in for full access

Log In

New to Red Hat?

Learn more about Red Hat subscriptions

Close

Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.