After installation with iBFT, the system doesn't boot with dracut error "FATAL: Resolving 0.0.0.0 via ARP on eth0 failed"
Issue
- After the installation with iBFT, the system doesn't boot up.
- The following errors were output on console.
dracut: FATAL: Resolving 0.0.0.0 via ARP on eth0 failed
dracut: Refusing to continue
dracut Warning: No root device "block:/dev/mapper/VolGroup-lv_root" found
And then,
Kernel panic - not syncing: Attempted to kill init!
- This was installed in private network, so there is no gateway configured in iBFT.
- The iscsi target is in the same subnet.
Environment
Red Hat Enterprise Linux 6.1
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.
