Problems trying to add a vlan network interface in a RHEV 3.1 environment due to duplicate entries.
Issue
The following errors may occur in the RHEV-M GUI when trying to add an unassigned logical network;
Cannot setup Networks. The following Network Interfaces can have only a single VM Logical Network, or at most one non-VM Logical Network and/or several VLAN Logical Networks: bond0.
Invalid list of interfaces, two or more network interfaces have the same IP.
Cannot setup Networks. The following Network Interfaces were specified more than once: bond0.xxx.
The sequence used to do this was;
- Host -> Network Interfaces -> Setup Host Networks.
- Then drag the new interface from 'Unassigned Logical Networks' and drop into 'Assigned Logical Networks'.
Environment
- Red Hat Enterprise Virtualization 3.1
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Close
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.