The boot parameter to configure a VLAN interface does not work on installation from Red Hat Enterprise Linux 7.3
Issue
- I am trying to install
Red Hat Enterprise Linux 7.3, and the kickstart file is on theVLANnetwork. - I used the following boot parameter in
Red Hat Enterprise Linux 7.2, and it worked completely.
ip=IP-ADDRESS gateway=GATEWAY-IP-ADDRESS netmask=NETMASK hostname=HOSTNAME ksdevice=em1 nameserver=DNS-SERVER-ADDRESS inst.ks=http://WEB-SERVER-NAME/.../ks.cfg vlan=vlan100:em1 ipv6.disable=1
- The
VLAN IDof localVLANnetwork is 100, and theVLANinterface should be created on a physical interfaceem1in this environment. - But, this same configuration doesn't work in
Red Hat Enterprise Linux 7.3. The specified IP address was assigned intoem1, though it's expected to assign into theVLANinterface. - How can I make it work again in
Red Hat Enterprise Linux 7.3?
Environment
Red Hat Enterprise Linux 7.3
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.
