Why "#cat /proc/net/bonding/bond*" shows "Link count failure =1" as even after reboot why this flag not got cleared ?
Issue
- Why "cat /proc/net/bonding/bond*" still showing "Link count failure =1"
- As even after reboot this flag not got cleared and log messages does not show any error message corresponding to it ?
#cat proc/net/bonding/bond1
Ethernet Channel Bonding Driver: v3.4.0-1 (October 7, 2008)
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth2
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:17:a4:77:c8:04
Slave Interface: eth5
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr: 00:17:a4:77:c8:08
Environment
- Red Hat Enterprise Linux 5
- Active-Backup bonding
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Close
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.