Show Table of Contents
3.6.3. Starting, Stopping and Restarting stunnel
To start stunnel, run the following command as
root:
~]#stunnel/etc/stunnel/stunnel.conf
By default, stunnel uses
/var/log/secure to log its output.
To terminate stunnel, kill the process by running the following command as
root:
~]# kill `cat /var/run/stunnel/stunnel.pid`
If you edit the configuration file while stunnel is running, terminate stunnel and start it again for your changes to take effect.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.