Bonding interface shows an erroneous primary slave
Issue
The bonding interface bond1 is showing as primary slave eth3 when eth3 does not belong to this bonding:
# cat /proc/net/bonding/bond1
Ethernet Channel Bonding Driver: v2.6.3-rh (June 8, 2005)
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: eth3
Currently Active Slave: eth4
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 500
Down Delay (ms): 500
Slave Interface: eth4
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:11:22:33:44:55
Slave Interface: eth7
MII Status: up
Link Failure Count: 0
Permanent HW addr: 55:44:33:22:11:00
Environment
Red Hat Enterprise Linux (RHEL) 4
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Close
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.