Anaconda does not strip newline from X-System-Serial-Number when using kssendsn
Issue
- When
kssendsn anacondaparameter is used, a http packet including a following message was sent.
X-System-Serial-Number: # SMBIOS implementations newer than version 2.7 are not
# fully supported by this version of dmidecode.
XXXXXXXXX
- NOTE: XXXXXXXXX was an serial number. It's replaced by XXXXXXXXX
- There are two problems here.
- some comments was sent, but it's not needed.
- There is a new line after XXXXXXXXX.
Environment
- Red Hat Enterprise Linux 6
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.
