bonding arp mode and flapping errors with be2net driver.

Solution Verified - Updated -

Issue

  • bonding arp mode and flapping errors with be2net driver.
  • See the below errors i logs

    bonding: bond0: Adding slave eth0.
    eth0: Link up
    bonding: bond0: making interface eth0 the new active one.
    bonding: bond0: first active interface up!
    bonding: bond0: enslaving eth0 as an active interface with an up link.
    ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready
    bonding: bond0: Adding slave eth1.
    eth1: Link up
    bonding: bond0: enslaving eth1 as a backup interface with an up link.
    bonding: bond0: Setting eth0 as primary slave.
    bonding: bond0: link status definitely down for interface eth0, disabling it
    bonding: bond0: making interface eth1 the new active one.
    bonding: bond0: link status definitely up for interface eth0.
    bonding: bond0: making interface eth0 the new active one.
    

Environment

  • Red Hat Enterprise Linux 5
  • be2net driver version: 2.102.115r
  • arp monitoring

Subscriber exclusive content

A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.

Current Customers and Partners

Log in for full access

Log In
Close

Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.