The NIC which has two IP addressses is not active always
Issue
- RHEL5 server has one Network Interface card with two IP addresses (eth0 and eth0:0); when it changes its network the eth0:0 address goes "inactive", but in both positions eth0 is "active".
We need also eth0:0 be network sensitive, i.e. when we are in 1st network eth0 active, in 2nd network eth0:0 be active.
Before a general electrical failure we had experienced it was working well.
Environment
- Red Hat Enterprise Linux (RHEL) 5
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Close
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.