Bonding shows unknown speed and duplex for one interface
Issue
- Bonding shows unknown speed and duplex for one interface, but they are shown by ethtool commend.
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2+3 (2)
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
802.3ad info
LACP rate: slow
Aggregator selection policy (ad_select): stable
Active Aggregator Info:
Aggregator ID: 1
Number of ports: 1
Actor Key: 33
Partner Key: 28
Partner Mac Address: 00:00:00:00:00:1c
Slave Interface: eth0
MII Status: up
Speed: 10000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 14:02:ec:84:b4:50
Aggregator ID: 1
Slave queue ID: 0
Slave Interface: eth1
MII Status: up
Speed: Unknown
Duplex: Unknown
Link Failure Count: 0
Permanent HW addr: 14:02:ec:84:b4:51
Aggregator ID: 2
Slave queue ID: 0
There is below message logged in messages file:
kernel: bond0: link status definitely up for interface eth1, 4294967295 Mbps full duplex.
Environment
- Red Hat Enterprise Linux 6.5
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.
