A bonding's primary setting is not effective
Issue
- A bonding's primary setting is not effective. How to fix this phenomenon?
/etc/sysconfig/network-scripts/ifcfg-bond0
BONDING_OPTS='mode=1 miimon=100 primary=eth0'
/proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.2.4 (January 28, 2008)
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None <----- here
Currently Active Slave: eth3
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth3
MII Status: up
Link Failure Count: 0
Permanent HW addr: XX:XX:XX:XX:XX:XX
Slave Interface: eth0
MII Status: up
Link Failure Count: 0
Permanent HW addr: XX:XX:XX:XX:XX:XX
Environment
- Red Hat Enterprise Linux 5.2
-
A bonding's option is in /etc/sysconfig/network-scripts/ifcfg-bond0
BONDING_OPTS='mode=1 miimon=100 primary=eth0'
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.
