Why did ethtool still show rx/tx off after run the command "ethtool -A eth0 rx on tx on" ?
Issue
-
However, when we use ethtool -a eth0 to check the state of the eth0, the rx/tx is still in off state.
ethtool -A eth0 rx on tx on
Environment
- Red Hat Enterprise Linux (RHEL) 4 Update 7
Subscriber exclusive content
A Red Hat subscription provides unlimited access to our knowledgebase of over 48,000 articles and solutions.
Close
Welcome! Check out the Getting Started with Red Hat page for quick tours and guides for common tasks.