In the Linux kernel, the following vulnerability has been resolved: net: nexthop: Increase weight to u16 In CLOS networks, as link failures occur at various points in the network, ECMP weights of the involved nodes are adjusted to compensate. With high fan-out of the involved nodes, and overall high number of nodes, a (non-)ECMP weight ratio that we would like to configure does not fit into 8 bits. Instead of, say, 255:254, we might like to configure something like 1000:999. For these deployments, the 8-bit weight may not be enough. To that end, in this patch increase the next hop weight from u8 to u16. Increasing the width of an integral type can be tricky, because while the code still compiles, the types may not check out anymore, and numerical errors come up. To prevent this, the conversion was done in two steps. First the type was changed from u8 to a single-member structure, which invalidated all uses of the field. This allowed going through them one by one and audit for type correctness. Then the structure was replaced with a vanilla u16 again. This should ensure that no place was missed. The UAPI for configuring nexthop group members is that an attribute NHA_GROUP carries an array of struct nexthop_grp entries: struct nexthop_grp { __u32 id; /* nexthop id - must exist */ __u8 weight; /* weight of this nexthop */ __u8 resvd1; __u16 resvd2; }; The field resvd1 is currently validated and required to be zero. We can lift this requirement and carry high-order bits of the weight in the reserved field: struct nexthop_grp { __u32 id; /* nexthop id - must exist */ __u8 weight; /* weight of this nexthop */ __u8 weight_high; __u16 resvd2; }; Keeping the fields split this way was chosen in case an existing userspace makes assumptions about the width of the weight field, and to sidestep any endianness issues. The weight field is currently encoded as the weight value minus one, because weight of 0 is invalid. This same trick is impossible for the new weight_high field, because zero must mean actual zero. With this in place: - Old userspace is guaranteed to carry weight_high of 0, therefore configuring 8-bit weights as appropriate. When dumping nexthops with 16-bit weight, it would only show the lower 8 bits. But configuring such nexthops implies existence of userspace aware of the extension in the first place. - New userspace talking to an old kernel will work as long as it only attempts to configure 8-bit weights, where the high-order bits are zero. Old kernel will bounce attempts at configuring >8-bit weights. Renaming reserved fields as they are allocated for some purpose is commonly done in Linux. Whoever touches a reserved field is doing so at their own risk. nexthop_grp::resvd1 in particular is currently used by at least strace, however they carry an own copy of UAPI headers, and the conversion should be trivial. A helper is provided for decoding the weight out of the two fields. Forcing a conversion seems preferable to bending backwards and introducing anonymous unions or whatever.

A flaw was found in the Linux kernel's nexthop networking component. The system uses a weight field to manage network traffic distribution, particularly in complex network environments known as CLOS networks. This field was limited to an 8-bit value, which is insufficient for modern, high-scale network configurations. A local attacker could potentially exploit this limitation, leading to incorrect network traffic handling, which may result in a denial of service (making network services unavailable) or the disclosure of sensitive network information.

This Moderate impact vulnerability in the Linux kernel addresses a potential for numerical errors when configuring Equal-Cost Multi-Path (ECMP) weights in CLOS networks. The issue arises from an insufficient 8-bit weight field, which could lead to incorrect weight ratios in deployments with high fan-out. Exploitation requires specific userspace configurations attempting to utilize weights exceeding 8 bits. Mitigation for this issue is either not available or the currently available options do not meet the Red Hat Product Security criteria comprising ease of use and deployment, applicability to widespread installation base, or stability. Red Hat Enterprise Linux 10 Not affected kernel Red Hat Enterprise Linux 6 Not affected kernel Red Hat Enterprise Linux 7 Not affected kernel Red Hat Enterprise Linux 7 Not affected kernel-rt Red Hat Enterprise Linux 8 Not affected kernel Red Hat Enterprise Linux 8 Not affected kernel-rt Red Hat Enterprise Linux 9 Affected kernel Red Hat Enterprise Linux 9 Fix deferred kernel-rt Red Hat Hardened Images Not affected erlang27 https://www.cve.org/CVERecord?id=CVE-2024-14040 https://nvd.nist.gov/vuln/detail/CVE-2024-14040 https://lore.kernel.org/linux-cve-announce/2026072658-CVE-2024-14040-ceac@gregkh/T