Red Hat Training

A Red Hat training course is available for Red Hat Enterprise Linux

4.18. 磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​您​​​​​​​的​​​​​​​系​​​​​​​統​​​​​​​

If you chose one of the three automatic partitioning options and did not select Review, skip ahead to 節 4.20, “網​​​​​​​路​​​​​​​設​​​​​​​定​​​​​​​”.
如​​​​​​​果​​​​​​​您​​​​​​​同​​​​​​​時​​​​​​​選​​​​​​​擇​​​​​​​自​​​​​​​動​​​​​​​分​​​​​​​割​​​​​​​磁​​​​​​​碟​​​​​​​和​​​​​​​ 檢​​​​​​​視​​​​​​​,您​​​​​​​可​​​​​​​以​​​​​​​選​​​​​​​擇​​​​​​​接​​​​​​​受​​​​​​​目​​​​​​​前​​​​​​​的​​​​​​​分​​​​​​​割​​​​​​​區​​​​​​​設​​​​​​​定​​​​​​​(請​​​​​​​點​​​​​​​選​​​​​​​ 下​​​​​​​一​​​​​​​步​​​​​​​),或​​​​​​​使​​​​​​​用​​​​​​​ Disk Druid(一​​​​​​​個​​​​​​​手​​​​​​​動​​​​​​​分​​​​​​​割​​​​​​​磁​​​​​​​碟​​​​​​​的​​​​​​​工​​​​​​​具​​​​​​​)來​​​​​​​更​​​​​​​改​​​​​​​設​​​​​​​定​​​​​​​。​​​​​​​

注意

請​​​​​​​注​​​​​​​意​​​​​​​,文​​​​​​​字​​​​​​​模​​​​​​​式​​​​​​​安​​​​​​​裝​​​​​​​除​​​​​​​了​​​​​​​瀏​​​​​​​覽​​​​​​​既​​​​​​​有​​​​​​​設​​​​​​​定​​​​​​​外​​​​​​​,無​​​​​​​法​​​​​​​與​​​​​​​ LVM(邏​​​​​​​輯​​​​​​​磁​​​​​​​區​​​​​​​)相​​​​​​​容​​​​​​​。​​​​​​​LVM 只​​​​​​​能​​​​​​​在​​​​​​​圖​​​​​​​形​​​​​​​化​​​​​​​的​​​​​​​ Disk Druid 的​​​​​​​圖​​​​​​​形​​​​​​​安​​​​​​​裝​​​​​​​模​​​​​​​式​​​​​​​下​​​​​​​進​​​​​​​行​​​​​​​設​​​​​​​定​​​​​​​。​​​​​​​
如​​​​​​​果​​​​​​​您​​​​​​​選​​​​​​​擇​​​​​​​建​​​​​​​立​​​​​​​一​​​​​​​個​​​​​​​自​​​​​​​訂​​​​​​​頁​​​​​​​面​​​​​​​,您​​​​​​​必​​​​​​​須​​​​​​​將​​​​​​​ Red Hat Enterprise Linux 的​​​​​​​安​​​​​​​裝​​​​​​​位​​​​​​​置​​​​​​​指​​​​​​​定​​​​​​​給​​​​​​​安​​​​​​​裝​​​​​​​程​​​​​​​式​​​​​​​。​​​​​​​這​​​​​​​是​​​​​​​經​​​​​​​由​​​​​​​定​​​​​​​義​​​​​​​一​​​​​​​或​​​​​​​多​​​​​​​個​​​​​​​安​​​​​​​裝​​​​​​​ Red Hat Enterprise Linux 的​​​​​​​掛​​​​​​​載​​​​​​​點​​​​​​​。​​​​​​​同​​​​​​​時​​​​​​​您​​​​​​​也​​​​​​​許​​​​​​​需​​​​​​​要​​​​​​​建​​​​​​​立​​​​​​​或​​​​​​​者​​​​​​​刪​​​​​​​除​​​​​​​一​​​​​​​個​​​​​​​磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​區​​​​​​​。​​​​​​​

注意

If you have not yet planned how to set up your partitions, refer to 章 25, 磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​區​​​​​​​的​​​​​​​介​​​​​​​紹​​​​​​​ and 節 4.18.4, “建​​​​​​​議​​​​​​​的​​​​​​​磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​摘​​​​​​​要​​​​​​​”. At a bare minimum, you need an appropriately-sized root partition, and a swap partition equal to twice the amount of RAM you have on the system. Itanium system users should have a /boot/efi/ partition of approximately 100 MB and of type FAT (VFAT), a swap partition of at least 512 MB, and an appropriately-sized root (/) partition.
在​​​​​​​ x86、​​​​​​​ AMD64 和​​​​​​​ Intel 64 系​​​​​​​統​​​​​​​上​​​​​​​使​​​​​​​用​​​​​​​ Disk Druid 執​​​​​​​行​​​​​​​磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​

圖形 4.15. 在​​​​​​​ x86、​​​​​​​ AMD64 和​​​​​​​ Intel® 64 系​​​​​​​統​​​​​​​上​​​​​​​使​​​​​​​用​​​​​​​ Disk Druid 執​​​​​​​行​​​​​​​磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​

安​​​​​​​裝​​​​​​​程​​​​​​​式​​​​​​​所​​​​​​​使​​​​​​​用​​​​​​​的​​​​​​​磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​工​​​​​​​具​​​​​​​是​​​​​​​ Disk Druid。​​​​​​​除​​​​​​​了​​​​​​​某​​​​​​​些​​​​​​​特​​​​​​​定​​​​​​​的​​​​​​​例​​​​​​​外​​​​​​​狀​​​​​​​況​​​​​​​外​​​​​​​,Disk Druid 可​​​​​​​對​​​​​​​應​​​​​​​基​​​​​​​本​​​​​​​安​​​​​​​裝​​​​​​​上​​​​​​​的​​​​​​​磁​​​​​​​碟​​​​​​​分​​​​​​​割​​​​​​​要​​​​​​​求​​​​​​​。​​​​​​​

4.18.1. 硬​​​​​​​碟​​​​​​​的​​​​​​​圖​​​​​​​形​​​​​​​顯​​​​​​​示​​​​​​​

Disk Druid 提​​​​​​​供​​​​​​​了​​​​​​​一​​​​​​​個​​​​​​​圖​​​​​​​形​​​​​​​化​​​​​​​的​​​​​​​硬​​​​​​​碟​​​​​​​顯​​​​​​​示​​​​​​​。​​​​​​​
使​​​​​​​用​​​​​​​您​​​​​​​的​​​​​​​滑​​​​​​​鼠​​​​​​​,按​​​​​​​一​​​​​​​下​​​​​​​以​​​​​​​選​​​​​​​取​​​​​​​在​​​​​​​圖​​​​​​​形​​​​​​​化​​​​​​​顯​​​​​​​示​​​​​​​裡​​​​​​​的​​​​​​​一​​​​​​​個​​​​​​​特​​​​​​​定​​​​​​​區​​​​​​​域​​​​​​​。​​​​​​​點​​​​​​​兩​​​​​​​下​​​​​​​以​​​​​​​編​​​​​​​輯​​​​​​​一​​​​​​​個​​​​​​​現​​​​​​​有​​​​​​​的​​​​​​​分​​​​​​​割​​​​​​​區​​​​​​​,並​​​​​​​指​​​​​​​定​​​​​​​一​​​​​​​個​​​​​​​掛​​​​​​​載​​​​​​​點​​​​​​​。​​​​​​​
Above the display, you can review the Drive name (such as /dev/hda), the Geom (which shows the hard disk's geometry and consists of three numbers representing the number of cylinders, heads, and sectors as reported by the hard disk), and the Model of the hard drive as detected by the installation program.