6.5. Editing health checks using the Developer perspective

Procedure

1. In the Topology view, right-click your application and select Edit Health Checks. Alternatively, in the side panel, click the Actions drop-down list and select Edit Health Checks.

2. In the Edit Health Checks page:

   • To remove a previously added health probe, click the minus sign adjoining it.

   • To edit the parameters of an existing probe:

     1. Click the Edit Probe link next to a previously added probe to see the parameters for the probe.
     2. Modify the parameters as required, and click the check mark to save your changes.

   • To add a new health probe, in addition to existing health checks, click the add probe links. For example, to add a Liveness probe that checks if your container is running:

     1. Click Add Liveness Probe, to see a form containing the parameters for the probe.

     2. Edit the probe parameters as required.

        注意

        The Timeout value must be lower than the Period value. The Timeout default value is 1. The Period default value is 10.

     3. Click the check mark at the bottom of the form. The Liveness Probe Added message is displayed.
3. Click Save to save your modifications and add the additional probes to your container. You are redirected to the Topology view.
4. In the side panel, verify that the probes have been added by clicking on the deployed pod under the Pods section.
5. In the Pod Details page, click the listed container in the Containers section.
6. In the Container Details page, verify that the Liveness probe - HTTP Get 10.129.4.65:8080/ has been added to the container, in addition to the earlier existing probes.