Red Hat Training

A Red Hat training course is available for Red Hat Enterprise Linux

33.5. Network Configuration

Network Configuration

Figure 33.8. Network Configuration

If the system to be installed via kickstart does not have an Ethernet card, do not configure one on the Network Configuration page.
Networking is only required if you choose a networking-based installation method (NFS, FTP, or HTTP). Networking can always be configured after installation with the Network Administration Tool (system-config-network). Refer to the Red Hat Enterprise Linux Deployment Guide for details.
For each Ethernet card on the system, click Add Network Device and select the network device and network type for the device. Select eth0 to configure the first Ethernet card, eth1 for the second Ethernet card, and so on.