11.5. Adding Errata to an incremental Content View

If errata are available but not installable, you can create an incremental Content View version to add the errata to your content hosts. For example, if the Content View is version 1.0, it becomes Content View version 1.1, and when you publish, it becomes Content View version 2.0.

  1. In the Satellite web UI, navigate to Content > Errata.
  2. From the Errata list, click the name of the errata that you want to apply.
  3. Select the content hosts that you want to apply the errata to, and click Apply to Hosts. This creates the incremental update to the Content View.

  4. If you want to apply the errata to the content host, select the Apply Errata to Content Hosts immediately after publishing check box.

    注記

    Until BZ#1459807 is resolved, if you apply non-installable errata to hosts registered to Capsule Servers, do not select the Apply errata to Content Hosts immediately after publishing check box.

    Instead, after clicking Confirm, wait for the errata Content View to be promoted and for the Capsule synchronization task to finish. Then, the errata will be marked as Installable and you can use the procedure again to apply it.

  5. Click Confirm to apply the errata.

For CLI Users

  1. List the errata and its corresponding IDs: 

    # hammer erratum list

  2. List the different content-view versions and the corresponding IDs: 

    # hammer content-view version list

  3. Apply a single erratum to content-view version. You can add more IDs in a comma-separated list. 

    # hammer content-view version incremental-update \
--content-view-version-id 319 --errata-ids 34068b