Red Hat Training

A Red Hat training course is available for Red Hat Enterprise Linux

12.6. Démarrage de l'installation

12.6.1. Installation à partir du DVD/CD-ROM

To install Red Hat Enterprise Linux from a DVD/CD-ROM, place the DVD or CD #1 in your DVD/CD-ROM drive and boot your system from the DVD/CD-ROM.
The installation program then probes your system and attempts to identify your CD-ROM drive. It starts by looking for an IDE (also known as an ATAPI) CD-ROM drive.
If your CD-ROM drive is not detected, and it is a SCSI CD-ROM, the installation program prompts you to choose a SCSI driver. Choose the driver that most closely resembles your adapter. You may specify options for the driver if necessary; however, most drivers detect your SCSI adapter automatically.
If the DVD/CD-ROM drive is found and the driver loaded, the installer will present you with the option to perform a media check on the DVD/CD-ROM. This will take some time, and you may opt to skip over this step. However, if you later encounter problems with the installer, you should reboot and perform the media check before calling for support. From the media check dialog, continue to the next stage of the installation process (refer to Section 12.12, « Red Hat Enterprise Linux vous souhaite la bienvenue »).

12.6.1.1. Que faire si le CD-ROM IDE n'est pas détecté ?

Si vous avez un DVD/CD-ROM IDE (ATAPI) mais que le programme d'installation ne le détecte pas et vous demande d'indiquer le type de lecteur DVD/CD-ROM dont vous disposez, essayez la commande de démarrage ci-dessous. Relancez l'installation, puis, à l'invite boot:, saisissez linux hdX=cdrom. Remplacez X par l'une des lettres suivantes, en fonction de l'interface à laquelle l'unité est connectée et selon son type de configuration, maître ou esclave (également appelé primaire et secondaire) :
  • a — premier contrôleur IDE, maître
  • b — premier contrôleur IDE, esclave
  • c — deuxième contrôleur IDE, maître
  • d — deuxième contrôleur IDE, esclave
Si vous disposez d'un troisième ou d'un quatrième contrôleur, continuez simplement à attribuer des lettres par ordre alphabétique, en passant d'un contrôleur à l'autre et du maître à l'esclave.