18.7. Creating Advanced RAID Devices
/bootor root file system arrays on a complex RAID device; in such cases, you may need to use array options that are not supported by Anaconda. To work around this, perform the following procedure:
Procedure 18.1. Creating Advanced RAID Devices
- Insert the install disk.
- During the initial boot up, select Rescue mode, the user will be presented with a command line terminal.instead of or . When the system fully boots into
- From this terminal, use
partedto create RAID partitions on the target hard drives. Then, use
mdadmto manually create raid arrays from those partitions using any and all settings and options available. For more information on how to do these, see Chapter 13, Partitions,
man parted, and
- Once the arrays are created, you can optionally create file systems on the arrays as well.
- Reboot the computer and this time select Anaconda searches the disks in the system, it will find the pre-existing RAID devices.or to install as normal. As
- When asked about how to use the disks in the system, selectand click . In the device listing, the pre-existing MD RAID devices will be listed.
- Select a RAID device, click Anaconda will perform the install to this pre-existing RAID device, preserving the custom options you selected when you created it in Rescue Mode.and configure its mount point and (optionally) the type of file system it should use (if you did not create one earlier) then click .
manpages. Both the
man mdcontain useful information for creating custom RAID arrays, and may be needed throughout the workaround. As such, it can be helpful to either have access to a machine with these
manpages present, or to print them out prior to booting into Rescue Mode and creating your custom arrays.