21.4. Parameters for Kickstart Installations
- References a Kickstart file, which usually resides on the network for Linux installations on IBM Z. Replace URL with the full path including the file name of the Kickstart file. This parameter activates automatic installation with Kickstart. See Kickstart Boot Options and Section 27.2.5, “Starting the Kickstart Installation” for more details.
ImportantThis parameter is deprecated. If you use it in a Kickstart file, it will be ignored. Only the
inst.ks=parameter is necessary to start a Kickstart installation on IBM Z.Where value is defined as 1 if you want to run the loader automatically on the Linux console without having to log in over the network with SSH. To use
RUNKS=1, the console must either support full-screen or the
inst.cmdlineoption (below) should be used. The latter applies for the 3270 terminal under z/VM or the operating system messages console for LPAR. We recommend
RUNKS=1for fully automatic installations with Kickstart. When
RUNKS=1is set, the installation program automatically continues in case of parameter errors and does not interrupt unattended installations by prompting for user interaction.Leave out the parameter or specify
- When this option is specified, output on line-mode terminals (such as 3270 under z/VM or operating system messages for LPAR) becomes readable, as the installation program disables escape terminal sequences that are only applicable to UNIX-like consoles. This requires installation with a Kickstart file that answers all questions, because the installation program does not support interactive user input in cmdline mode.
inst.cmdlineoption. If a required command is missing, the installation will fail. See Chapter 27, Kickstart Installations for details.