Red Hat Training
A Red Hat training course is available for Red Hat Virtualization
A.3. Updating the Hosts
Use the host upgrade manager to update individual hosts directly from the Red Hat Virtualization Manager.
The upgrade manager only checks hosts with a status of Up or Non-operational, but not Maintenance.
On RHVH, the update only preserves modified content in the /etc and /var directories. Modified data in other paths is overwritten during an update.
- If migration is enabled at the cluster level, virtual machines are automatically migrated to another host in the cluster. Update a host when its usage is relatively low.
- Ensure that the cluster contains more than one host before performing an update. Do not update all hosts at the same time, as one host must remain available to perform Storage Pool Manager (SPM) tasks.
- Ensure that the cluster to which the host belongs has sufficient memory reserve for its hosts to perform maintenance. Otherwise, the virtual machine migration operation will hang and fail. You can reduce the memory usage of this operation by shutting down some or all virtual machines before updating the host.
- You cannot migrate a virtual machine using a vGPU to a different host. Virtual machines with vGPUs installed must be shut down before updating the host.
Ensure that the correct repositories are enabled (to view a list of currently enabled repositories, type
For Red Hat Virtualization Hosts:
# subscription-manager repos --enable=rhel-7-server-rhvh-4-rpms
For Red Hat Enterprise Linux hosts:
# subscription-manager repos \ --enable=rhel-7-server-rpms \ --enable=rhel-7-server-rhv-4-mgmt-agent-rpms \ --enable=rhel-7-server-ansible-2.9-rpms
- In the Administration Portal, click Compute → Hosts and select the host to be updated.
Click Installation → Check for Upgrade and click OK.
Click the Events and alerts notification icon ( ) and expand the Events section to see the result.
- If an update is available, click Installation → Upgrade.
Click OK to update the host. Running virtual machines will be migrated according to their migration policy. If migration is disabled for any virtual machines, you will be prompted to shut them down.
The details of the host are updated in Compute → Hosts and the status transitions through these stages:
If any virtual machines were migrated off the host, they are now migrated back.Note
If the update fails, the host’s status changes to Install Failed. From Install Failed you can click Installation → Upgrade again.
Repeat this procedure for each host in the Red Hat Virtualization environment.
Red Hat recommends updating the hosts from the Manager; however, you can also update the hosts using