Red Hat Training

A Red Hat training course is available for Red Hat Virtualization

Chapter 20. Proxies

20.1. SPICE Proxy

20.1.1. SPICE Proxy Overview

The SPICE Proxy is a tool used to connect SPICE Clients to virtual machines when the SPICE Clients are outside the network that connects the hypervisors. Setting up a SPICE Proxy consists of installing Squid on a machine and configuring the firewall to allow proxy traffic. Turning a SPICE Proxy on consists of using engine-config on the Manager to set the key SpiceProxyDefault to a value consisting of the name and port of the proxy. Turning a SPICE Proxy off consists of using engine-config on the Manager to remove the value to which the key SpiceProxyDefault has been set.

Important

The SPICE Proxy can only be used in conjunction with the standalone SPICE client, and cannot be used to connect to virtual machines using noVNC.

20.1.2. SPICE Proxy Machine Setup

This procedure explains how to set up a machine as a SPICE Proxy. A SPICE Proxy makes it possible to connect to the Red Hat Virtualization network from outside the network. We use Squid in this procedure to provide proxy services.

Installing Squid on Red Hat Enterprise Linux

  1. Install Squid on the Proxy machine:

    # yum install squid
  2. Open /etc/squid/squid.conf. Change:

    http_access deny CONNECT !SSL_ports

    to:

    http_access deny CONNECT !Safe_ports
  3. Start the proxy:

    # systemctl start squid.service
  4. Open the default squid port:

    # iptables -A INPUT -p tcp --dport 3128 -j ACCEPT
  5. Make this iptables rule persistent:

    # service iptables save

You have now set up a machine as a SPICE proxy. Before connecting to the Red Hat Virtualization network from outside the network, activate the SPICE proxy.

20.1.3. Turning On a SPICE Proxy

This procedure explains how to activate (or turn on) the SPICE proxy.

Activating SPICE Proxy

  1. On the Manager, use the engine-config tool to set a proxy:

    # engine-config -s SpiceProxyDefault=someProxy
  2. Restart the ovirt-engine service:

    # systemctl restart ovirt-engine.service

    The proxy must have this form:

    protocol://[host]:[port]
    Note

    Only SPICE clients shipped with Red Hat Enterprise Linux 6.7, Red Hat Enterprise Linux 7.2, or later, support HTTPS proxies. Earlier clients only support HTTP. If HTTPS is specified for earlier clients, the client will ignore the proxy setting and attempt a direct connection to the host.

SPICE Proxy is now activated (turned on). It is now possible to connect to the Red Hat Virtualization network through the SPICE proxy.

20.1.4. Turning Off a SPICE Proxy

This procedure explains how to turn off (deactivate) a SPICE proxy.

Turning Off a SPICE Proxy

  1. Log in to the Manager:

    $ ssh root@[IP of Manager]
  2. Run the following command to clear the SPICE proxy:

    # engine-config -s SpiceProxyDefault=""
  3. Restart the Manager:

    # systemctl restart ovirt-engine.service

SPICE proxy is now deactivated (turned off). It is no longer possible to connect to the Red Hat Virtualization network through the SPICE proxy.