Red Hat Training

A Red Hat training course is available for Red Hat Satellite

13.5. Changing the Life Cycle Environment or Content View of a Host Collection

The following procedure shows how to change the assigned life cycle environment or content view of host collections.

Procedure 13.6. To Change the Life Cycle Environment or Content View of a Host Collection:

  1. Click Hosts → Host Collection.
  2. Selection the host collection where the life cycle environment or content view should be changed.
  3. On the Collection Actions tab, click Change assigned Life Cycle Environment or Content View.
  4. Select the life cycle environment to be assigned to the host collection.
  5. Select the required content view from the drop-down list.
  6. Click Assign.

    Note

    The changes take effect in approximately 4 hours. To make the changes take effect immediately, on the host, enter the following command: 
    # subscription-manager refresh
    You can use remote execution to run this command on multiple hosts at the same time.