Show Table of Contents
4.2.3. Installing Behind a HTTP Proxy: Pre-Configuration
Due to the way that Red Hat Network Satellite uses the
rhn.conf to control its connection settings, there is no way to add options to that file prior to installation of Red Hat Network Satellite. If your network is behind an HTTP proxy in your organization, you cannot activate the Red Hat Network Satellite at installation time. A workaround to this issue is to first perform a disconnected installation of Red Hat Network Satellite, then switch the configuration to a connected method after installation is completed. The following demonstrates how to create a connected Red Hat Network Satellite installation behind an HTTP proxy:
Procedure 4.4. Installing Satellite behind an HTTP Proxy - Pre-Configuration
- Complete a minimal installation of Red Hat Enterprise Linux 5 or 6.
- Configure the system so that it can connect to Red Hat Network behind the HTTP proxy. Edit the file
/etc/sysconfig/rhn/up2dateas follows:enableProxy=1 enableProxyAuth=1 httpProxy=<http-proxy-fqdn> proxyUser=<proxy-username> proxyPassword=<proxy-password>
- Register the system to Red Hat Network.
- Begin the installation of Red Hat Network Satellite with the disconnected option:
./install.pl --disconnected
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.