Show Table of Contents
Appendix B. Verify Your Red Hat JBoss Fuse Service Works Installation
After you complete the JBoss Fuse Service Works installation, you can verify if the product has been installed successfully.
Note
The installer creates a summary of the installation in
EAP_HOME/InstallationLog.txt.
- If the installer encountered any problems during installation, the installer will display an error message to the user. You can find out more information by viewing the
EAP_HOME/InstallationLog.txtfile. - If no error was reported, you can perform additional verification by performing the following steps:
- Start the server by running
standalone.shcommand - Open the
server.logfile to check if any error messages have been logged and that SwitchYard (and other component subsystems) have loaded correctly - Navigate to the Management Console (http://localhost:9990/) check that you can see the SwitchYard Runtime properties.
- Compile, deploy and run a quickstart application.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.