Red Hat Training

A Red Hat training course is available for Red Hat Fuse

7.2. Manual Deployment


You can manually deploy and undeploy bundles by issuing commands at the Red Hat JBoss Fuse console.

Installing a bundle

Use the osgi:install command to install one or more bundles in the OSGi container. This command has the following syntax:
osgi:install [-s] [--start] [--help] UrlList
Where UrlList is a whitespace-separated list of URLs that specify the location of each bundle to deploy. The following command arguments are supported:
Start the bundle after installing.
Same as -s.
Show and explain the command syntax.
For example, to install and start the bundle, ProjectDir/target/foo-1.0-SNAPSHOT.jar, enter the following command at the Karaf console prompt:
osgi:install -s file:ProjectDir/target/foo-1.0-SNAPSHOT.jar
On Windows platforms, you must be careful to use the correct syntax for the file URL in this command. See Section A.1, “File URL Handler” for details.

Uninstalling a bundle

To uninstall a bundle, you must first obtain its bundle ID using the osgi:list command. You can then uninstall the bundle using the osgi:uninstall command (which takes the bundle ID as its argument).
For example, if you have already installed the bundle named A Camel OSGi Service Unit, entering osgi:list at the console prompt might produce output like the following:
[ 175] [Active     ] [            ] [Started] [   60] ServiceMix :: FTP (2009.02.0.psc-01-00RC1)
[ 181] [Resolved   ] [            ] [       ] [   60] A Camel OSGi Service Unit (1.0.0.SNAPSHOT)
You can now uninstall the bundle with the ID, 181, by entering the following console command:
osgi:uninstall 181

URL schemes for locating bundles

When specifying the location URL to the osgi:install command, you can use any of the URL schemes supported by Red Hat JBoss Fuse, which includes the following scheme types: