Show Table of Contents
Chapter 3. Install JBoss Fuse on JBoss EAP
Prerequisites
JBoss Fuse must be installed on JBoss EAP 6.4. If you need to install JBoss EAP 6.4, download it from JBoss EAP 6.4 Installer Download. See JBoss EAP 6.4 Installation Guide for installation instructions.
Important
We also recommend that you apply the latest patch to JBoss EAP 6.4. The JBoss EAP patch level should be at least 6.4.7, to avoid known issues. Patches are available from the JBoss EAP 6.4 Patches tab of the download page.
Install JBoss Fuse using Installer
- Download Red Hat JBoss Fuse 6.2.1 on EAP Installer to a temporary location on your file system.
- Navigate to $EAP_HOME of a clean instance of JBoss EAP.
- Run the installer with the following command:
java -jar temporary location/fuse-eap-installer-6.2.1.redhat-084.jar
Note
Once a datastore has been has been selected at installation, it can not be changed.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.