Show Table of Contents
Chapter 35. Set Up Cross-Datacenter Replication
In Red Hat JBoss Data Grid, Cross-Datacenter Replication allows the administrator to create data backups in multiple clusters. These clusters can be at the same physical location or different ones. JBoss Data Grid's Cross-Site Replication implementation is based on JGroups'
RELAY2 protocol.
Cross-Datacenter Replication ensures data redundancy across clusters. Ideally, each of these clusters should be in a different physical location than the others.
35.1. Cross-Datacenter Replication Operations
Red Hat JBoss Data Grid's Cross-Datacenter Replication operation is explained through the use of an example, as follows:
Example 35.1. Cross-Datacenter Replication Example
Figure 35.1. Cross-Datacenter Replication Example
Three sites are configured in this example:
LON, NYC and SFO. Each site hosts a running JBoss Data Grid cluster made up of three to four physical nodes.
The
Users cache is active in all three sites - LON, NYC and SFO. Changes to the Users cache at the any one of these sites will be replicated to the other two as long as the cache defines the other two sites as its backups through configuration. The Orders cache, however, is only available locally at the LON site because it is not replicated to the other sites.
The
Users cache can use different replication mechanisms each site. For example, it can back up data synchronously to SFO and asynchronously to NYC and LON.
The
Users cache can also have a different configuration from one site to another. For example, it can be configured as a distributed cache with owners set to 2 in the LON site, as a replicated cache in the NYC site and as a distributed cache with owners set to 1 in the SFO site.
JGroups is used for communication within each site as well as inter-site communication. Specifically, a JGroups protocol called
RELAY2 facilitates communication between sites. For more information, see Section F.4, “About RELAY2”
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.