Show Table of Contents
3.3. Installing Samba Using yum
To install Samba using yum, install the Samba group using the following command:
# yum groupinstall RH-Gluster-Samba-Server
If you require Samba Active Directory integration with gluster, execute the following command:
# yum groupinstall RH-Gluster-AD-Integration
For more information about installing Red Hat Gluster Storage using yum, see Section 2.3, “Installing Red Hat Gluster Storage Server on Red Hat Enterprise Linux (Layered Install)”.
Samba can also be installed by following these steps:
- To install the basic Samba packages, execute the following command:
# yum install samba
- If you require the
smbclienton the server, then execute the following command:# yum install samba-client
- If you require an Active directory setup, then execute the following commands:
# yum install samba-winbind # yum install samba-winbind-clients # yum install samba-winbind-krb5-locator
- Verify if the following packages are installed.
samba-libs samba-winbind-krb5-locator samba-winbind-modules samba-vfs-glusterfs samba-winbind samba-client samba-common samba-winbind-clients samba
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.