Show Table of Contents
10.4.2. qpid-route Syntax
The syntax of
qpid-route is as follows:
qpid-route [OPTIONS] dynamic add <dest-broker> <src-broker> <exchange> qpid-route [OPTIONS] dynamic del <dest-broker> <src-broker> <exchange> qpid-route [OPTIONS] route add <dest-broker> <src-broker> <exchange> <routing-key> qpid-route [OPTIONS] route del <dest-broker> <src-broker> <exchange> <routing-key> qpid-route [OPTIONS] queue add <dest-broker> <src-broker> <dest-exchange> <src-queue> qpid-route [OPTIONS] queue del <dest-broker> <src-broker> <dest-exchange> <src-queue> qpid-route [OPTIONS] route list [<broker>] qpid-route [OPTIONS] route flush [<broker>] qpid-route [OPTIONS] route map [<broker>] qpid-route [OPTIONS] link add <dest-broker> <src-broker> qpid-route [OPTIONS] link del <dest-broker> <src-broker> qpid-route [OPTIONS] link list [<dest-broker>]
The syntax for
broker, dest-broker, and src-broker is as follows:
[username/password@] hostname | ip-address [:<port>]
The following are all valid examples of the above syntax:
localhost, 10.1.1.7:10000, broker-host:10000, guest/guest@localhost.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.