Show Table of Contents
1.3. Storage Array Support
By default, DM Multipath includes support for the most common storage arrays that themselves support DM Multipath. For information on the default configuration values, including supported devices, run either of the following commands.
#multipathd show config#multipath -t
If your storage array supports DM Multipath and is not configured by default, you may need to add it to the DM Multipath configuration file,
multipath.conf. For information on the DM Multipath configuration file, see Chapter 4, The DM Multipath Configuration File.
Some storage arrays require special handling of I/O errors and path switching. These require separate hardware handler kernel modules.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.