Show Table of Contents
14.5.7. Modifying the Link State of a Domain's Virtual Interface
The following command can either configure a specified interface as up or down:
# domif-setlink[domain][interface-device][state]{--config}
Using this modifies the status of the specified interface for the specified domain. Note that if you only want the persistent configuration of the domain to be modified, you need to use the
--configoption. It should also be noted that for compatibility reasons, --persistent is an alias of --config. The "interface device" can be the interface's target name or the MAC address.
# domif-setlink rhel6 eth0 up
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.