Red Hat Training

A Red Hat training course is available for Red Hat Enterprise Linux Controlling I/O Operations on a RAID1 Logical Volume

As of the Red Hat Enterprise Linux release 6.5, you can control the I/O operations for a device in a RAID1 logical volume by using the --writemostly and --writebehind parameters of the lvchange command. The format for using these parameters is as follows.
  • --[raid]writemostly PhysicalVolume[:{t|y|n}]
    Marks a device in a RAID1 logical volume as write-mostly. All reads to these drives will be avoided unless necessary. Setting this parameter keeps the number of I/O operations to the drive to a minimum. The default behavior is to set the write-mostly attribute for the specified physical volume in the logical volume. It is possible to remove the write-mostly flag by appending :n to the physical volume or to toggle the value by specifying :t. The --writemostly argument can be specified more than one time in a single command, making it possible to toggle the write-mostly attributes for all the physical volumes in a logical volume at once.
  • --[raid]writebehind IOCount
    Specifies the maximum number of outstanding writes that are allowed to devices in a RAID1 logical volume that are marked as write-mostly. Once this value is exceeded, writes become synchronous, causing all writes to the constituent devices to complete before the array signals the write has completed. Setting the value to zero clears the preference and allows the system to choose the value arbitrarily.