Show Table of Contents
5.4.10. Changing the Parameters of a Logical Volume Group
To change the parameters of a logical volume, use the
lvchange command. For a listing of the parameters you can change, see the lvchange(8) man page.
You can use the
lvchange command to activate and deactivate logical volumes. To activate and deactivate all the logical volumes in a volume group at the same time, use the vgchange command, as described in Section 5.3.8, “Changing the Parameters of a Volume Group”.
The following command changes the permission on volume
lvol1 in volume group vg00 to be read-only.
# lvchange -pr vg00/lvol1
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.