Show Table of Contents
5.3.8. Changing the Parameters of a Volume Group
The
vgchange command is used to deactivate and activate volume groups, as described in Section 5.3.9, “Activating and Deactivating Volume Groups”. You can also use this command to change several volume group parameters for an existing volume group.
The following command changes the maximum number of logical volumes of volume group
vg00 to 128.
# vgchange -l 128 /dev/vg00
For a description of the volume group parameters you can change with the
vgchange command, see the vgchange(8) man page.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.