Show Table of Contents
13.3.4. Select an Installation Server Target That Includes a Driver Update
- Configure the computer to boot from the network interface by selecting
Select Boot Optionsin the SMS menu, thenSelect Boot/Install Device. Finally, select your network device from the list of available devices. - In the yaboot installation server environment, choose the boot target that you prepared on your installation server. For example, if you labeled this environment
rhel6-ddin the/var/lib/tftpboot/yaboot/yaboot.conffile on your installation server, typerhel6-ddat the prompt and press Enter.
Refer to Section 13.2.3, “Preparing an Initial RAM Disk Update” and Chapter 30, Setting Up an Installation Server for instructions on using a yaboot installation server to perform an update during installation. Note that this is an advanced procedure — do not attempt it unless other methods of performing a driver update fail.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.