Show Table of Contents
6.3.4. Select a PXE Target that Includes a Driver Update
- Select
network bootin your computer's BIOS or boot menu. The procedure to specify this option varies widely among different computers. Consult your hardware documentation or the hardware vendor for specifics relevant to your computer. - In the preboot execution environment (PXE), choose the boot target that you prepared on your PXE server. For example, if you labeled this environment
rhel6-ddin the/var/lib/tftpboot/pxelinux/pxelinux.cfg/defaultfile on your PXE server, typerhel6-ddat the prompt and press Enter.
Refer to Section 6.2.3, “Preparing an Initial RAM Disk Update” and Chapter 30, Setting Up an Installation Server for instructions on using PXE to perform an update during installation. Note that this is an advanced procedure — do not attempt it unless other methods of performing a driver update fail.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.