Show Table of Contents
18.2.2. Installation Phase 1
After the kernel boot, you will configure one network device. This network device is needed to complete the installation.
The interface you will use in installation phase 1 is the linuxrc interface, which is line-mode and text-based. (Refer to Chapter 21, Installation Phase 1: Configuring a Network Device.)
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.