4.7. Eaton Network Power Switch

Table 4.8, “Eaton Network Power Controller (SNMP Interface) (Red Hat Enterprise Linux 6.4 and later)” lists the fence device parameters used by fence_eaton_snmp, the fence agent for the Eaton over SNMP network power switch.

Table 4.8. Eaton Network Power Controller (SNMP Interface) (Red Hat Enterprise Linux 6.4 and later)

luci Field cluster.conf Attribute Description
Name name A name for the Eaton network power switch connected to the cluster.
IP Address or Hostname ipaddr The IP address or host name assigned to the device.
UDP/TCP Port (optional) udpport The UDP/TCP port to use for connection with the device; the default value is 161.
Login login The login name used to access the device.
Password passwd The password used to authenticate the connection to the device.
Password Script (optional) passwd_script The script that supplies a password for access to the fence device. Using this supersedes the Password parameter.
SNMP Version snmp_version The SNMP version to use (1, 2c, 3); the default value is 1.
SNMP Community community The SNMP community string; the default value is private.
SNMP Security Level snmp_sec_level The SNMP security level (noAuthNoPriv, authNoPriv, authPriv).
SNMP Authentication Protocol snmp_auth_prot The SNMP authentication protocol (MD5, SHA).
SNMP Privacy Protocol snmp_priv_prot The SNMP privacy protocol (DES, AES).
SNMP Privacy Protocol Password snmp_priv_passwd The SNMP privacy protocol password.
SNMP Privacy Protocol Script snmp_priv_passwd_script The script that supplies a password for SNMP privacy protocol. Using this supersedes the SNMP privacy protocol password parameter.
Power wait (seconds) power_wait Number of seconds to wait after issuing a power off or power on command.
Power Timeout (seconds) power_timeout Number of seconds to continue testing for a status change after issuing a power off or power on command. The default value is 20.
Shell Timeout (seconds) shell_timeout Number of seconds to wait for a command prompt after issuing a command. The default value is 3.
Login Timeout (seconds) login_timeout Number of seconds to wait for a command prompt after login. The default value is 5.
Times to Retry Power On Operation retry_on Number of attempts to retry a power on operation. The default value is 1.
Port (Outlet) Number port Physical plug number or name of virtual machine. This parameter is always required.
Delay (optional) delay The number of seconds to wait before fencing is started. The default value is 0.
Figure 4.7, “Eaton Network Power Switch” shows the configuration screen for adding an Eaton Network Power Switch fence device.
Eaton Network Power Switch

Figure 4.7. Eaton Network Power Switch

The following command creates a fence device instance for an Eaton Network Power Switch device:
ccs -f cluster.conf --addfencedev eatontest agent=fence_eaton_snmp ipaddr=192.168.0.1 login=root \
 passwd=password123 power_wait=60 snmp_priv_passwd=eatonpassword123 udpport=161
The following is the cluster.conf entry for the fence_eaton_snmp device:

 <fencedevices>
  <fencedevice agent="fence_eaton_snmp" community="private" ipaddr="eatonhost" login="eatonlogin" \
   name="eatontest" passwd="password123" passwd_script="eatonpwscr" power_wait="3333" \
   snmp_priv_passwd="eatonprivprotpass" snmp_priv_passwd_script="eatonprivprotpwscr" udpport="161"/>
 </fencedevices>