Show Table of Contents
22.16.7. Adding a Broadcast Client Address
To add a broadcast client address, that is to say, to configure a broadcast address to be monitored for broadcast
NTP packets, make use of the broadcastclient command in the ntp.conf file.
The
broadcastclient command takes the following form:
broadcastclient
Enables the receiving of broadcast messages. Requires authentication by default. See Section 22.6, “Authentication Options for NTP”.
This command configures a system to act as an
NTP client. Systems can be both client and server at the same time.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.