Show Table of Contents
34.4.1. Starting the
34.4. TFTPD
34.4.1. Starting the tftp Server
On the DHCP server, verify that the
tftp-server package is installed with the command rpm -q tftp-server. If it is not installed, install it via Red Hat Network or the Red Hat Enterprise Linux CD-ROMs. Note
For more information on installing RPM packages, refer to the Package Management Section of the Red Hat Enterprise Linux Deployment Guide.
tftp is an xinetd-based service; start it with the following commands:
/sbin/chkconfig --level 345 xinetd on/sbin/chkconfig --level 345 tftp on
These commands configure the
tftp and xinetd services to immediately turn on and also configure them to start at boot time in runlevels 3, 4, and 5.
Where did the comment section go?
Red Hat's documentation publication system recently went through an upgrade to enable speedier, more mobile-friendly content. We decided to re-evaluate our commenting platform to ensure that it meets your expectations and serves as an optimal feedback mechanism. During this redesign, we invite your input on providing feedback on Red Hat documentation via the discussion platform.